Bolens 190-746-000 - Manual (Page 6)

16.
17.
18.
FIGURE 8
FIGURE 9
Place the large compression spring (U) over the
slotted end of lift rod assembly (W).
Place slotted end of lift rod (with spring
attached) over the rod on right hand side of tiller^
as shown in figure 8. Secure with flat washe
(B) and hairpin cotter (J).
Using a 3/4" or adjustable wrench, tighten the
hex nut which is on the lift rod assembly until
the spring is compressed to 11" long (pages of
this manual are 11" long). See figure 8.
Thread adjustment ferrule (P) on other end of
lift rod assembly a few turns. See figure 9, inset.
Place the tiller in position behind the tractor.
Slide the tiller forward so the lift rod assembly
and ferrule go through the slot in the right hand
fender on the tractor. See figure 9.
NOTE
On models prior to 1984, it is
necessary to extend the slot in the
fender approximately 1-1/2" further
down toward the running board. The
slot should measure approximately
4-3/8".
There are two weld pins on the front of the tiller.
Push the tiller forward, then to the left so the
weld pins go through the bottom hole in the
pivot support brackets. See figures 10 and 11.
Secure the weld pin on the right hand side of
tiller using spacer (Q) and hairpin cotter (J). See
figure 10.
FIGURE 10