Steering wheel installation, Note, Figure 13 – Bolens 135-688-000 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Plastic
Bushing
in Dash
Panel
Clevis
Pin (I)
Upper Steering
Shaft
Hairpin Cotter (J)
Lower Steering
Shaft
STEERING WHEEL INSTALLATION
1.-----For shipping purposes, the upper steering
shaft is pushed ail the way down over the
lower steering shaft. Pull the upper steering
shaft up. The four holes in the shaft provide
four steering wheel heights. Select desired
hole and secure with clevis pin (I) and hairpin
------cotter (J). See figure 12.
NOTE
On model 668, the four adjustment
holes are located above the dash
panel.
FIGURE 12.—Model 698 Shown
Steering
Bellow (D)
2. Attach steering bellow (D) to the steering
wheel as shown in figure 13.
NOTE
One end of the steering bellow is
slightly larger than the other. The
larger end must be assembled to the
steering wheel.
FIGURE 13.
Belleville
Washer (B)
Hex Nut (C)
3. Place steering wheel and bellow on the steer
ing shaft, lining up the flats in the wheel with
the flats on the shaft.
4. Secure with belleville washer (B) (cupped side
against the steering wheel) and hex nut (C).
— See figure 14.
5. Press the steering wheel cap (A) on the steer
ing wheel by hand.
FIGURE 14.