Bolens 115-500-000 - Manual (Page 13)

Trouble Shooting Chart
Problem Cause Remedy
1 Engine fails to start A Blade control handle A Engage blade control handle.
disengaged
B Fill tank if empty. B Check fuel tank for gas
C Spark plug lead wire discon­
nected.
C Connect lead wire.
D Throttle control lever not in D Move throttle lever to start
the starting position position.
E Faulty spark plug E Spark should jump gap be­
tween control electrode and
side electrode. If spark does
not jump, replace the spark
plug.
F Carburetor Improperly ad- F Remove spark plug, dry the
justed, engine flooded plug, crank engine with plug
removed, and throttle in off po­
sition. Replace spark plug and
lead wire and resume starting
procedures.
G Old stale gasoline G Drain and refill with fresh
gasoline.
H Engine brake engaged H Follow starting procedure.
2 Hard starting or A Spark plug wire loose A Connect and tighten spark
loss of power plug wire.
B Carburetor improperly B Adjust carburetor. See separate
adjusted engine manual.
C Dirty air cleaner C Clean air cleaner as described
in separate engine manual.
3 Operation erratic A Dirt in gas tank A Remove the dirt and fill tank
with fresh gas.
B Dirty air cleaner B Clean air cleaner as described
in separate engine manual.
C Water in fuel supply C Drain contaminated fuel and
fill tank with fresh gas.
D Vent in gas cap plugged D Clear vent or replace gas cap.
E Carburetor improperly E Adjust carburetor. See
adjusted separate engine manual.
4 Occasional skip A Carburetor idle speed too A Adjust carburetor. See
(hesitates) at high slow separate engine manual.
speed B Spark plug gap too close B Adjust to .030".
C Carburetor idle mixture ad- C Adjust carburetor. See
justment improperly set separate engine manual.
5 Idles poorly A Spark plug fouled, faulty, or A Reset gap to .030" or replace
gap too wide spark plug.
B Carburetor improperly B Adjust carburetor. See
adjusted separate engine manual.
C Dirty air cleaner C Clean air cleaner as described
in separate engine manual.
6 Engine overheats A Carburetor not adjusted A Adjust carburetor. See
properly separate engine manual.
B Air flow restricted B Remove blower housing and
clean as described in separate
engine manual.
C Engine oil level low C Fill crankcase with the proper
oil.
7 Excessive vibration A Cutting blade loose or A Tighten blade and adapter.
unbalanced Balance blade.
B Bent cutting blade B Replace blade.
Note: For repairs beyond the minor adjustments iisted above, contact vour local authorized service deaier.
13