AEG 4159 - Manual (Page 37)

Water drainage
Drain hose connection:
maximum allowable height: 1 metre;
minimum necessary height of 30 cm over lower edge of machine.
For extension hoses, which may be laid horizontally to max. 3 m length, the
maximum allovyable height of the drain hose connection is 85 cm.
Cmportant notel Thedrain hose must not be kinked, squashed, or twisted. Please
ensure careful running.
Sink trap connection
The hose connection (19 mm dia.) supplied with the dishwasher will fit all
commonly available makes of sink trap.
The unobstructed width of the sink trap connection should not be less than '
15 mm.
The drain hose must be fastened to the sink trap connection with the hose clip
supplied.
Water drainage into a sink
if you want to run the drain hose on a free-standing machine into a sink, you
should use an attachable hose bend. You can obtain this hose bend from your
AEG service centre under spare part number ET 646 069 190. Fit the bend to
the drain hose.
Important notel Make sure that the drain hose does not slip off the edge of the.
sink.
If you draw a string through the hole, you can also mount the bend on a wall £«nd
thus prevent it from slipping off.
Extension hoses
Suitable extension hoses can be ordered from your specialist retailer and original
hoses from our service centre. The inside diameter of these extension hoses must
be 19 mm to prevent any loss of machine function.
77