Chicago Electric Power Tools / 6 AMP Reciprocating Saw With Rotating Handle 65570 - Manual (Page 12)

Page 12 For technical questions, please call 1-800-444-3353. Item 65570
maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO pRevent SeRiOuS inJuRY FROm aCCiDental OpeRatiOn:
Squeeze and release the trigger and unplug the tool from its electrical
outlet before performing any procedure in this section.
tO pRevent SeRiOuS inJuRY FROm tOOl FailuRe:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, maintenance, and lubrication
1. BeFORe eaCh uSe, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. aFteR uSe, wipe external surfaces
of the tool with clean cloth.
3. Periodically blow dust and grit out of the motor vents
using dry compressed air. Wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection while doing this.
4. Check the condition of Blades regularly.
Bent, cracked, worn or dull blades will not
operate properly and can cause damage or
injury. Discard damaged or worn blades.
5. WaRninG! if the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup