AEG SANTO 3900 E - Manual (Page 4)

9. INSTALLATION
See drawings (1) and (2) page 12.
Install the cabinet in a dry place and so that
it is not exposed to direct sunlight or any
other source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base. The
cabinet should not rest against a wall on its
hinged side. When placing the cabinet on a
carpet or on a wooden floor you should
adjust it once more after some time as the
cabinet might settle in soft foundations.
The cabinets can be built in or put side by
side, see fig. (2b) page 12.
KF models put side by side with other
models require a distance of 2 inches
between the appliances.
For sufficient aidlovy around the cabinet it is
necessary to have a 4inches high air duct
right above the appliance, see fig. (2a) and
(2b) or an air duct that teeds the air up over
the top cupboard, see fig. (2c).
Make sufficient space for door opening as to
draw the baskets out, see fig. (2e).
The dimensions for building in are noted on
the drawings.
During a storm the electricity supply might
be cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not immediately
observe that the power has been cut off.
Construction and details in the accessories
are subject to alteration without previous
notice.
If the cabinet is to be adjusted:
See drawings (1) page 12
Take hold of the front panel with both hands.
Then lift up the front panel and turn out the
bottom part.
Adjust the tilt of the unit
See drawings (1) page 12
by turning the adjustable feet with a 13 mm
spanner.
10. CHANGE OF HINGE SIDE
See drawings page 14.
1. Dismantle the top hinge. This one is to
be used later as top hinge at the
opposite side. Lift off the top door.
2. Dismantle the middle hinge. Lift off the
bottom door. Mount the hinge screws
again,
3. Dismantle the screws in the middle of
the new hinge side. Mount the bottom
door and screw on the middle hinge.
4. Remove the kick panel.
a) Only for appliances with a door closer
on the bottom door. The door closer is
moved to the second hole.
b) The bottom hinge is dismounted at the
3 screws. The hinge is turned 90° and
mounted on the opposite side.
5. Adjusting the bottom door: Loosen the
3 screws in the bottom hinge and push
the bottom hinge to the required side.
Tighten the screws and mount the kick
panel.
6) The kick panel is mounted and the hole
plugs are mounted on the opposite
sideg.
7. Ajustment of the top door: loosen the
screws in the hinge above the door,
loosen the hinge above the door and
turn the hinge to the wanted side.
Tighten the screws.
8. Move the handle.
DISPOSAL OF THE
APPLIANCE
The appliance contains recyclable
materials. When disposing of the
appliance, please contact the technical
administration or other appropriate
authority in your municipality. They can
inform you of the collection and recycling
measures used in the municipaiity.