AEG 302D - Manual (Page 14)

Installing the hood
to the wall
14
It is possible to fix the hood in position, if necessary, by only
attaching it to the rear wall.
Proceed as follows:
1. Drill the four holes on the wall as indicated (Fig. 11).
2. Insert the four rawl plugs supplied into these holes.
3. Screw the two mountings hooks into the top two rawl plugs
(Fig. 12).
4. Dismount the spacer M (Fig. 12) from the body of the hood by
unscrewing completely the two spacer fixing screws O and
washers.
5. Fix the base spacer M to the wall (Fig. 12) with the two screws
R 5x45 provided (Fig. 11) using either the long or the short arm,
depending on the depht of the side cupboards.
Do not tighten the screws fully.
6. Fix the hood to the wall by means of the two hooksP previously
mounted, but first move the upper brackets S (Fig. 11) so that
the front panel of the hood, once mounted, will be in line with
the front edge of the cupboard doors. The two upper brackets
S, located at the top rear edge of the hood may be slid
backwards and forwards by loosening its fixing screws T
adjacent to them on the upper hood surface (Fig. 11).
7. Check that the hood is at the right height. Minor height
adjustments may be made with the screws U embodied in the
brackets (see Fig. 11).
8. Tighten the two wall fixing screws R, through the two access
holes N provided on the inside of the hood (Fig. 12) then fix the
lower sliding frame to the hood with two screws O and washers
previously unscrewed (item 4).