Allied Telesis 195 - Manual (Page 11)

General Instructions and Information
As with any piece of equipment, the care with which your loader is operated
and maintained wiii greatly affect it's iife and the safety of the people using it.
1. Keep ali pivots weli iubricated for ionger bushing iife. Inspect every 500
hours of operation for wear.
2. Periodicaliy check ali boits for tightness. If any bolt is damaged, replace it
with a boit of equivaient grade or strength.
3. Foliow the recommendations of the tractor manufacturer in regards to the
quantity of oii used.
4. Check oii level frequently to ensure the system is fuii.
5. When making an oii check, be sure iift cylinders are retracted.
6. Before operating the loader, particularly if the loader is left standing for
any length of time, check the hydrauiic system and oil level.
7. When installing hydrauiics, foilow the circuit carefuiiy. See hydraulic
hook-up section and make sure the hoses do not contact any hot
manifolds or sharp edges on tractor. After assembly, raise the loader slowly
and check to make sure that the hoses do not bind in all positions.
CAUTION I
The pressure of the relief and open centre valves is set at the factory. Do
not tamper with the setting. Serious injury to the operator or damage to the
loader or tractor hydraulics may occur. Warranty will be void if the loader is
operated above recommended pressure.
8. When servicing any hydraulic components, care must be taken to prevent
any foreign matter from entering the system.
9. Do not neglect oil leaks. Leaks affect loader operation, are dangerous and
can result in personal injury or damage to the hydraulic system.
10. Never leave the cylinder shafts exposed when loader is not in use.
11. Worn or damaged components should be replaced as soon as possible with
only the manufacturer's recommended component or equivalent.