CLIFFORD 562C - Manual (Page 29)

25
© 2004 Directed Electronics, Inc.
QUICK REFERENCE GUIDE:
To lock using your remote
■ To arm the system press
for one second. The doors will lock (if con-
nected). The LED will begin to flash. The Failsafe
®
Starter Kill will pre-
vent the vehicle’s starter from cranking if it has been installed. The ve-
hicle’s horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.
To unlock using your remote
■ To disarm the system press
for one second. The doors will unlock (if
connected). The Failsafe
®
Starter Kill will
be deactivated and the vehicle’s horn (if connected) will honk twice and
the parking lights will flash twice.
Disabling the Failsafe ® Starter Kill without a transmitter
■ Turn on the ignition. Press and release the Valet ®
switch within 10 sec-
onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet
®
switch.
To remote start the vehicle
■ Press
twice within 3 seconds. The parking lights will turn on (if con-
nected) and the vehicle will start and run for the programmed amount
of time.
To enter or exit Valet ® Mode
■ Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet
®
switch within 10 seconds. The status LED will
light steadily if you have entered Valet
®
Mode. To exit Valet
®
Mode,
repeat the steps above. The LED will turn off when exiting Valet
®
Mode.
To activate Panic Mode
■ Press and hold
for 1.5 seconds.
To disable the remote start system
■ To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Shutdown Switch______________________________ Cut along dotted line and f
old f
or a quick and eas
y
r
efer
ence to k
eep in y
our pur
se or w
allet.
✂
✂