Channel Vision ID850 - Manual (Page 2)

2
Model ID850
Installation:
h
h
h
h
h
h
Use the included template to mark and cut an 9.5” hole in
drywall away from ceiling joists.
We recommend wiring with AWG 16 or larger, stranded
wire.
For proper phasing, both voice coils must be wired alike.
Connect red wires to red terminals on speaker and to red
or plus terminals on amplifier.
Install ID850 in hole. Tighten the mounting screws. The
mounting dog ears will rotate outward and grip the
drywall.
Aim tweeters
To control the volume of the speaker locally, use an
impedance matching volume control, such as the
Channel Vision VC302.
Mounting screws (4)
3
Specifications:
Frequency range:
Sensitivity:
Power Handling:
Drivers:
Impedance:
Finish:
Dimensions:
Weight:
55Hz - 20kHz ± 3dB
90dB
75 Watts RMS (106 Watts Peak)
2- ½” Mylar dome tweeter
1- 8” polypropylene woofer
8 ohms
ABS plastic
10¾” OD. 4” height
(from surface of wall board)
5 Lbs as shipped
Specifications subject to change without notice.
Features:
Dual voice coil speaker delivers stereo sound from a single
speaker
Use when only one speaker will fit or to balance coverage in
a whole house audio system
Use in bathrooms, hallways, entry ways
8” Mica-filled polypropylene woofer with true rubber
surround
Dual ½" fluid-cooled ultra-wide dispersion mylar tweeters
Tweeters swivel independently up to 45 degrees
Tweeter protection using thermal sensing polymer switches
18 dB/octave crossover network
Mounting template and paint shield included
Recommended power: 5W to 100W