Craftsman 316.79194 - Manual (Page 5)

5
Cutting
Attachment Shield
Fuel
Cap
Throttle
Control
D-Handle
HassleFree™
Shaft Grip
Primer
Bulb
Oil Fill Plug
Cold
Starting
Lever
Spark Plug
Shaft
Housing
Starter
Rope
Grip
Line
Cutting
Blade
Muffler
Craftsman®
Convertible™
Coupler
On/Off Stop
Control
KNOW YOUR TRIMMER
Air Filter
Cover
ASSEMBLY INSTRUCTIONS
ADJUSTING THE D-HANDLE
1. Loosen the screws on the D-handle (Fig. 1).
2. While holding the unit in the
operating position (Fig. 2), position
the D-handle to the location that
provides you the best grip.
3. Tighten the clamp screws evenly,
until the D-handle is secure.
INSTALL LINE TRIMMER
ATTACHMENT
NOTE: To make installation easier, place
the unit on the ground or on a
workbench.
1. Turn knob counterclockwise to loosen
coupler (Fig. 15, p. 8).
2. While firmly holding attachment, push
it straight into the coupler until the
release button snaps into the primary
hole (Fig. 16, p. 8).
NOTE: Aligning the release button with the guide recess (Fig. 16,
p. 8) will help installation.
3. Turn the knob clockwise to tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative trimming
around trees, fences, etc.
Fig. 1
(4) Screws
Shaft Grip
Shaft
Housing
On/Off Stop Control
Minimum 6 Inches
(15.24 cm)
D-Handle
Bottom Clamp
Fig. 2
Trimmer
Attachment
WARNING: DO NOT ATTEMPT TO USE THIS UNIT
UNTIL THE D-HANDLE HAS BEEN ROTATED INTO
OPERATING POSITION (Fig. 1).