Amerec 3K User Manual

Amereo, Amerec steambath generators, Models; ak4, ak5, ak6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

AMEREO

AK and 3K Series with R30K Controi Owners Manual

AMEREC STEAMBATH GENERATORS

(MODELS; AK4, AK5, AK6,

AK7,

AK8.5, AK10,

3K8,

3K10, 3K12, 3K14)

SAVE THIS MANUAL

Thank you for purchasing your new AMEREC steam generator. If we can be of any assistance do

not hesitate to cai! our Service Department at 1-800-331-0349.

FOR THE SAFETY OF YOU AND YOUR FAMILY PLEASE READ THE WARNINGS TO

THE RIGHT AND ALL INSTRUCTIONS BEFORE USING YOUR STEAMBATH.

POST”STEAMBATH INSTRUCTIONS” LABEL OUTSIDE STEAMBATH FOR SAFETY

WARNINGS.

SECTION 1 : OPERATION OF YOUR NEW AMEREC GENERATOR

1. Assure that both the power circuit and water
suppiy to the generator are ON

2. To activate the steam press the controi on. In 10
to 20 minutes the room shouid be comfortable enough
to begin taking a steam bath. The unit wit! turn off
automatically in 30 minutes. The average time spent
taking a steam bath is approximately 10 minutes.

3. Remove clothing and jewelry.

4. Enter the steam room and close the door to prevent

steam from escaping

5. Relax and enjoy the warm steam releasing tense

muscles and refreshing the entire body

6. If your steam room has a shower, a pleasant
experience can be achieved by taking a warm shower
while in the steam. You will find the contrast from
water to steam quite invigorating

7. Pressing the control while the steam generator is
operating will shut it off

8 The R30K control does not provide automatic
temperature control. Use the on/off button to controi
the temperature as desired

SECTION 2: MAINTENANCE OF THE AK SERIES

The steam generator, steam head, fittings and plumb­

ing connections should be inspected annually for

water leaks and damage

The AK steam generator is equipped with a drain
valve forflushing sediments from the generatortank.
This procedure should be scheduled monthly or

more often depending on local water conditions and

steam bath usage

FLUSHING PROCEDURE
1. The generator should be cool
2. Turn control on.

3 Open the drain valve.

4

The unit will drain without heating the water

5. Allow the water to run 10 minutes
6 Close the drain valve

WARNING

Electric Shock Hazard

-

High voltage exists

within this equipment There are no user

serviceable parts in this equipment All
installaiion and service to this equipment
should be performed by qualified licensed

personnel.

Do not exceed 30 minutes in a steambath.
Excessive exposure can he harmful to your

health. Excessive exposure can produce a

rapid puise, iight-headedness, weakness

or fainting, if you become uncomforlahle
or experience any of the above conditions
exit the steambath immediately.

Steambaths can put undue stress on the
body. Therefore a steambath should be
used only under a doctors direction if you:

Are pregnant

Have a heart condition
Have high blood pressure
Have circulatory problems

Are under the influence of alcohol
Are under the influence of drugs

Have diabetes

Are under the care of a physician
Are in generally poor health

Children shouid only use the steambath

under close aduit supervision.

Scald Hazard: Do Not Touch the steam

head or trim during operation as they are

HOT. Stay at least 12 inches away from the

hot steam escaping from the steam head.
It is recommended that the steambath not
be operated for more than one timer cycle

wiihoutaitowing the steam hath enclosure

to cool because of the following:

Certain construction materials may be
damaged by the higher than normal heat.

A scald hazard could be presented by bath

fixtures overheating.

Be careful when entering a steambath.
Escaping steam from an overheated steam
room may cause injury.

«09-38 9-15-04

Advertising
This manual is related to the following products:

AK, R30K