Audiovox AV-970 - Manual (Page 9)

FOnD-LINCOLH-MEIICUIIYIIfSTALLATIDK - 1985 AND NEWER
ImPBftant'This instalfation is designed for mosl 1985 through 1990 U.S, made Ford oars, and vans and an
Installationkitisrequiredfofthesevebicles.SeeKiflistingon Page 2ofthismanLiaior refer to thein-Btoreappllcalion
chart. For 1991 and newer vehicles, Ihe radio can be installed as shown on Page Э of this manual or you can use
the AX-ee-SN P kit. instructions tor use of the AS-B8-SNP kitareindudedwiththekitandarenot shown in this marmaf.
1. RHsn Exlxtliig Паё1а:
A. Remove existing dashboard irimpanei surrounding the radio operring. This panel is usually secured by sore ws
and/or snap-in clips.
B. Remove the screws used to secure radio to the sub-dashboard.
C. Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-pfug the wiring hamess(es) and antenna cable and remove the radio.
2. hstillllH NmlMI«:
A. Follow the irrstmctions included with the installation kit to attach the radio to the mounting plate supplied with
the kit.
B. Place the radio rrear the dashboard so the wire can be led through the opening and following the Inslmclions
of Step 2 on Page 7, carefully wire the radio making certain ali connections are secure and insulated and
confirm proper operation.
C. Install the r^dio/mountlng plate assembly to the sub-dashboard according to instructions of installation kit.
D. Attach one end of Ihe perforated support strap (supplied) to the screw stud on the radio using the hex nut
provided. FastentheotherendoftheperForatedstraptoasecurepartofthedashboardeitheraboveorbelow
the radio usirtg the screw and nut provided. Bend Ihe strap lo position ft as necessary.
СА1ШШ1 The rear of the radio musí be supported with tbe strap to preveni damage to the dashboard from the
weight of the radio or improper operation of Ihe radio due to vibration.
E. Replace the dashboard trtmpanei.
F. Install knobs on radio shafts.