AEG FAVORIT 146 - Manual (Page 6)

The machine may be connected
a) directly to a tap with yt," B.S.P. Thread
termination
b) to a T-junction on your existing tap
or preferably
c) to a completely separate water supply
in order to avoid the interference with
the kitchen water supply during opera­
tion of the machine.
A connection to a hot water supply up to
a maximum of 60 Is possible, although
the machine must not be connected to
single outlet instantaneous electric or
gas heaters.
Minimum water pressure: approx 1 bar
pressure above atmospheric pressure
(1 ato = approx. 1 kp/cm* = approx.
10N/cm»).
For less than one bar of pressure above
atmospheric pressure, consult the Serv­
icing Engineer.. Maximum permissible
water pressure: approx. 10 bars. For over
10 bars excess pressure, connect a pres­
sure relief valve in series (Type AD 723,
E.-NO. 612.896.723).
If a longer water supply hose is needed it
should be a simple run of high pressure
bursting strength of 60 bars. Do not add
extenslone to hoses. Under no circum­
stances should cheap garden hoses or
similar types be used. Please also ensure
that hoses are connected by means of
screw connections with suitable hose
clips.
Turn off the water tap If the machine Is
not In use.
It Is not unusual to find a small amount of
water in your new dishwasher which re­
mains from our thorough factory checks.
Water outlet
Your dishwasher is fitted with a water
pump, controlled by the programme to
pump off the water. With a sink not more
6
than 85 cm above the floor level the
maximum hose extension is 3 m. The out­
let hose should never be more than 1 m
above floor level and at least 30 cm above
floor level.
The outlet hose (internal diameter 19 mm]
has a bend for hanging over the edge of
the sink. If the sink edge is too wide, fit the
hose support provided as illustrated below
or fasten the support to the water tap.
Make sure that the outlet hose is installed
along the left hand side in the base of the
machine.
The recess at the back of the machine
offers sufficient space to accomodate the
outlet hose for installation to the left or
right of the machine (see illustration).