Aiwa HV-MX100U - Manual (Page 29)

l b t u n c y o i i i T X ' t o t h e V C R S e t t i n g t h e V C R c h a n n e l s
If you connected the VCR to the TV with a 21-pin scart
cab e, this, procedure is hot necessary.
NX |j
I CHANNEL >rl
, LOW
Before starting
In PAL area, check that REC SYSTEM-PAL and OUTPUT
SYSTEM-PAL on the VCR are pressed.
In SECAM area, check that REC SYSTEM-SECAM/
MESECAM and OUTPUT SYSTEM-SECAM on the VCR
are pressed.
1
Press POWER to turn on the VCR.
2
Turn on the TV and select the TV channel
position you want to use for VCR playback.
3
Tune the TV so that the aiwa blue picture
appears clearly on the TV screen.
Refer to the TV operating instructions for tuning.
4
Press POWER to turn off the VCR.
Now the output from the VCR is tuned to this channel.
Whenever you want to play back a tape, select this
channel position.
If you cannot get a clear picture in step 3
Change the RF channel to another channel which does not
receive any station signal between 30 and 39 (the default is
channel 36) by turning the CHANNEL selector with a
screwdriver. Then repeat the above procedure from step 1.
Consult your dealer if you have any trouble with this
adjustment.
/
iv
When you can receive both PAL and SECAM, for example in
border areas, choose the same REC system which is being
broadcasted.
When you move to a different country, perform the Channel
Auto Set again.
The VCR can preset up to 100 channels in PAL or SECAM
area.
1
Press MENU.
2
Press A/T to move the cursor ( [ ? ) to
CHANNEL SET, then press
1 PRO G RAM TIM ER
2 CLO CK SET
3 CO LO R SYSTEM
4 AUDIO SETUP
5 VCR SETUP
6 LANG UAG E
> CHANNEL SET
SELECT: PV»A
ENTER
END : P®
Press A/T to move the cursor ([? ) to
CHANNEL AUTO SET, then press ►.
A scan bar appears on the TV screen and all available
channels in your area are scahned and stored in the
memory of the VCR.
After scanning, the first located channel appears on the
TV screen.
^.pM ANNLLSE T :
^ c f ®HANNEL AUTO SET
^CHANNEL M ANUAL S ET
c- ■
TITLE CH 1
imm 1
SELECT: PT-A
ENTER:^
END : P® ■
PLEASE \NMJ
EXIT :P®
If “AERIAL?” appears in the display
window after Channel Auto Set
Check the antenna connections and repeat from step 1.
If you still cannot receive the channels, set the VCR
channels manually. See below.
(Presetting the VCR channels is necessary for recording TV
programs.)
S o t t i n g t h e V C R c h c i n n o l s m t i n U i i l l y
If the Channel Auto Set does not set the VCR channels
correctly, set them manually for recording TV programs.
1
Follpw the steps 1 and 2 above.
2
Press A/T to move the cursor ([? ) to
CHANNEL MANUAL SET, then press ►.
M ANUAL SET
SELECT : PT»A
ENTER
END : P®
I
CONTINUE
ENGLISH 2 8