Mounting, Desk-top mounting, Tb-adm10 – Aiphone TB-ADM10 User Manual
Page 5: When wall-mounted with tb-m (and tb-g), 5 mounting
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MOUNTING
• Desk-top mounting
Wall-mounting
TB-ADM10
1. Remove 2 screws on front panel, removing 2 covers.
2. Lift off front case holding sides at top.
3. Disconnect TB-ADM10, plugging off connector.
4. Open a cable inlet hole (rubber part) on rear or bottom of chassis.
5. Pull in cable(s), and make wire terminations.
6. Use attached cable clamp(s) for neat and secured connection.
7. Reconnect and mount front case to chassis, attaching the covers to place.
★ For wall-mounting, the chassis must be mounted upside down.
When wall-mounted with TB-M (and TB-G)
Decide an exact location of TB-M master, and the next unit(s) atachedly mounts with the guides below;
TB-M master TB-G add-on TB-ADM10
selector
Wall-mounting guide
Unit: mm
Master
Attached
Guide A
Attached
Guide B
TB-10M
TB-20G
202.5
TB-ADM10
172.5
TB-40G
277.5
TB-ADM10
247.5
TB-ADM10
225.0
—
—
TB-20M
TB-20G
240.0
TB-ADM10
172.5
TB-40G
315.0
TB-ADM10
247.5
TB-ADM10
262.5
—
—
★ Processing conductor end
5C-2V or
RG-59/U (20GA)
3C-2V or
RG-59/U (22GA)
11mm (7/16”)
3mm (1/8”)
li'v
Fold back
8.5mm (3/8”)