Audiovox PC100 - Manual (Page 5)

4. RECEIVING A CALL When your POCKETPHONE is dialed,
the bleeper will ring and the green light
will flash.
Press the SND key to answer the call;
the green light will now remain
illuminated.
NOTE: If your POCKETPHONE is in
the locked position, you will not be
able to receive a call.
5. ENDING A CALL When the conversation has finished or
the called number does not answer,
press the END key. This terminates
the call.
6. TURNING OFF THE
POCKETPHONE
Press the A key. Press the LOCK
key. The POCKETPHONE is now
■locked’ and SWITCHED OFF. Calls
cannot be initiated or received in this
mode 'Memory’ functions are not
affected when the POCKETPHONE is
'locked' unless it has remained
unused for several months.
7. SWITCHING ON THE Press *RCL to switch on the phone
UNLOCK CODE Press *RCL again
Enter your SIX digit Security Number.
Press *RCL
Enter the UNLOCK CODE you wish to
use ¡4 digits) and this appears on the
display, together with the above.
Finally press the *RCL key again and
the display clears, leaving the
UNLOCK CODE ON.
The phone can now only be unlocked
using the UNLOCK CODE.
8. CHANGING THE
UNLOCK CODE This IS the same procedure as
SWITCHING ON THE UNLOCK CODE,
except that the phone does not have to
be unlocked before the new UNLOCK
CODE can be entered.
Controls and Keyboard
Operations
1. LITE This illuminates the display. Press the
LITE key The display will illuminate
and will remain illuminated for five
seconds after the LITE key has been
pressed.
In the car mode the display remains
illuminated continuously.
2. MUTE The MUTE key turns off the
microphone so you may make
comments without being overheard by
the person on the phone Pressing the
MUTE key again reconnects the
microphone. Each time the
microphone is turned off, the display
shows MUTE'. The microphone is
reconnected automatically when the
END key is pressed or the phone is
locked.
3. RING This key IS used to vary Ihe volume
level of the ringer. You can vary
between three levels; OFF, NORMAL,
and LOUD. To change the ringer level
setting, press key for the desired
level, locking the phone does nol
change this level. ‘NOTE; Even it the
ringer is turned olí, the green light will
flash indicating an incoming call but
no Ring will be heard.
4. VOLUME This key IS used to vary the volume
level of the earpiece. You can vary the
volume to three levels, V —, V and
V ■. with level V ■ as the loudest. To
change the volume setting, press the
key for the level you desire. The
volume will remain at this selling until
changed
5. UP ARROW This function key, A, is used to initiate
various operations described in this
booklet. UP ARROW must first be
pressed to initiate A/B SYSTEM
SELECT, CAR, hTEADSET, LOCK,
RECALL and STORAGE functions.
These keys and the A “Function" key
are highlighted in blue.