Dialogic DSI SPCI Network Interface Boards - Manual (Page 104)

7 CONFIGURATION COMMAND Reference
104
<cic_mask>
A 32 bit mask with bits set to indicate which circuits are to be allocated to the
circuit group. Bit zero must always be set as it represents the
base_cic/base_cid. Subsequent bits represent the subsequent circuits. Note
that ANSI circuit groups are not permitted to contain more than 24 circuits.
<options>
A 32 bit value containing run-time options for the ISUP circuit group (see
"Configure Circuit Group Request" section of the ISUP Programmer’s Manual).
Bits 0 through 15 are equivalent to the "options" field and bits 16 through 31
represent the "ext_options" field as detailed in the ISUP Programmer’s
Manual.
<user_inst>
The instance number of the user application. Typically only a single user
application exists so this field would be set to zero.
<user_id>
The module_id of the user application.
<opc>
Originating Point Code. The local point code for all circuits in the group.
<ssf>
The value to be used in the sub-service field of all ISUP messages for this
circuit group.
<variant>
The protocol "variant" for this circuit group. Refer to the ISUP Programmer’s
Manual for full details.
<options2>
A 32 bit value containing additional run-time options for the ISUP circuit
group (see "Configure Circuit Group Request" section of the ISUP
Programmer’s Manual). Bits 0 through 31 are equivalent to the
"ext_1_options" as detailed in the ISUP Programmer’s Manual.