Denso OFFICE PRO 12 - Manual (Page 12)

6
INSTALLATION (cont.)
Plugging in the Unit
• Check the prongs and surface of the power cord plug for dust/dirt. If
dust and/or dirt are present, wipe off with a clean, dry cloth.
• Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact your MovinCool
reseller for repair.
• For the Office Pro 24 model, fully insert plug into the A/C outlet and
rotate clockwise until it locks in place.
ƽWARNING:
• If the power cord or plug is damaged, repair should only be
performed by qualified electrical personnel.
• Do not connect/disconnect the power cord or attempt to
operate buttons with wet hands. This could result in electrical
shock.
ƽCAUTION:
• Office Pro 12 model ONLY: The AC outlet (115 VAC Single Phase,
60Hz) needs to be rated at 15A or higher. Do not share the outlet
with any other instrument or equipment.
• Office Pro 24 model ONLY: The AC outlet (208/230 VAC Single
Phase, 60Hz) needs to be rated at 20A or higher. Do not share
the outlet with any other instrument or equipment.
NOTE:
• Make sure the AC outlet is free of dirt, dust, oil, water, or any
other foreign matter.
• The Office Pro 12 model is equipped with an approved NEMA
plug configuration (L5-15). The appropriate outlet must be used
for this plug type.
• The Office Pro 24 model is equipped with an approved NEMA
plug configuration (L6-20). The appropriate outlet must be used
for this plug type.