DCS BGB36-BQAR - Manual (Page 5)

4
For personal safety, wear proper apparel. Loose fitting garments or sleeves should never be worn while
using this appliance. Some synthetic fabrics are highly flammable and should not be worn while cook-
ing. Only certain types of glass, heat-proof glass ceramic, earthenware, or other glazed utensils are suit-
able for grill use. These types of materials may break with sudden temperature changes. Use only on
low or medium heat settings according to the manufacturer’s directions.
WARNING:
Spiders and insects can nest in the burners of this and any other grill, and cause
the gas to flow from the front of the burner. This is a very dangerous condition
which can cause a fire to occur behind the valve panel, thereby damaging the
grill components and making it unsafe to operate.
WARNING:
Keep the area surrounding the grill free from combustible materials, trash, or
combustible fluids and vapors such as gasoline or charcoal lighter fluid. Do
not obstruct the flow of combustion and ventilation air.
WARNING:
Never use the grill in windy conditions. If located in a consistently windy area
(oceanfront, mountaintop, etc.) a wind break will be required. Always adhere
to the specified clearances listed.
PREFERRED AIR FLOW
GRILL EXHAUST
EXHA
UST
FLAME
BURNER
WIND
WIND
PRIMAR
Y
INT
AKE
AIR FL
OW
EXHAUST VENT FLOW
GRILL PLACEMENT
Do not use aluminum foil to line drip pans or grill racks. This can severely upset combustion air
flow or trap excessive heat in the control area. The result of this can be melted knobs or ignition
buttons.
Begin by insuring proper installation and servicing. Follow the installation instructions
provided with this product. Have your grill installed by a qualified technician. Have the installer
show you where the gas supply shut off valve is located so that you know where to shut off the
gas to the grill. If you smell gas, your installer has not done a proper job of checking for leaks.
If the connections are not perfectly sealed, you can have a small leak and therefore a faint gas
smell. Finding a leak is not a “do-it-yourself ” procedure. Some leaks can only be found with the
burner control in the “ON” position and this must be done by a qualified technician.
SAFETY PRACTICES & PRECAUTIONS