Dish Network DVR 942 - Manual (Page 17)

7
P ROGRAMMING THE R EMOTE TO C ONTROL A S ECOND
R ECEIVER IN A UX M ODE
If you have another DISH Network satellite receiver installed, you can
use this remote in AUX mode to control it along with your new
receiver. When you program the remote to control the other receiver,
the remote will send out IR and UHF (not UHF Pro) signals to the
receiver. You can program the remote to control any other DISH
Network satellite receiver, except for following:
• TV2 on DISH 322, DISH Player-DVR models 522, 625, and 942
• DishPlayer 7100/7200
1. Turn on the other receiver and display the System Info screen
(see the receiver user’s guide for information on how to display
the screen).
Write down the address shown:
2. Press and hold the AUX button until all the other mode buttons
light up, and then let go of the button. The AUX button flashes.
3. Press the 3 button.
4. Use the NUMBER PAD to enter the address you wrote in
step 1.
5. Press POUND (#). The AUX button blinks three times.
6. Press RECORD to make sure the address and the remote matches
the address on the receiver.
R EADING O UT THE R EMOTE C ONTROL C ODES
These instructions explain how to check the remote control code you
put in the remote control when you set it up. Be sure to write them in
the spaces provided below.
Instructions Additional Information
1 Press and hold the mode
button for the equipment
you want the remote to con-
trol. When all the other
mode buttons light up, let
go of the mode button - that
mode button should now be
flashing.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, the TV mode light
will flash.
62book.book Page 7 Tuesday, April 4, 2006 1:45 PM