Directed Electronics G322R - Manual (Page 22)

19 © 2 0 0 3 d i r e c t e d e l e c t r o n i c s , i n c .
step 12
Testing the system
With all the previous steps completed, the operation of the
system can now be tested.
■
Close all the doors and press the button on the transmitter,
the system should chirp one time.
■
At this point the system will go through diagnostics, a 15 second
process in which the security system will analyze the status of all
connected zones.
■
After 15 seconds open the driver side door, the alarm should
emit a series of chirps to indicate a security breach, after several
chirps the system will go into full trigger and the siren will
sound.
■
At any point during the chirps or full trigger press the but-
ton again and the system should turn off.
■
Rearm the system and test the remainder of the doors.
■
After testing the doors sit in the vehicle and close the doors,
rearm the system and after 15 seconds turn the key on, the sys-
tem will emit a series of chirps and then go into full trigger, at
this time attempt to start the vehicle it should NOT crank.
■
Press the button on the transmitter to disarm the system
and cycle the ignition key off, on, off to reset the system.
■
Rearm the system, wait 15 seconds and lightly bump the tire
with your foot, the system should emit a series of chirps, kick the
tire a little harder and the system should go into full trigger.
■
Disarm the system.
This completes the testing, if all functions and zones do not
➜