Denon AVR-1707 - Manual (Page 47)

ENGLISH
43
ENGLISH
Advanced Setup – Part 1
Advanced Setup – Part 2
• If the “Auto Setup” procedure has already been performed, there is
no need to make this setting.
• Perform this setting if you wish to make the settings for your
speaker systems manually.
Speaker Setup
Press ENTER or H H to enter the setting and switch to
the Subwoofer Mode Setup setting.
Setting the Speaker Configuration
Automatically set the output component and properties for the
various channels according to the combination of speakers to be
actually used for surround playback.
Press F F G G to select “1. Sp”, then press ENTER .
Press D D H H to select the speaker, then press F F G G to set.
Large:
Select this when using large speakers with ample low frequency
reproduction capabilities.
Small:
Select this when using small speakers without ample low
frequency reproduction capabilities.
Yes / No:
Select “Yes” when a subwoofer is connected, “No” when no
subwoofer is connected.
None:
Select this when no speaker is connected.
2sp / 1sp:
Select the number of surround back speakers.
1
2
A subwoofer with sufficient low frequency playback capability
can better handle deep bass than most main and surround
speakers, and the system’s overall performance will be greatly
enhanced when “Small” is set for the main (front) and surround
speakers.
When “Front” is set to “Small”, “Subwoofer” is automatically set
to “Yes”, and when “Subwoofer” is set to “No”, “Front” is
automatically set to “Large”.
3
About the button names in this explanation
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
ENTER
D H F G
D H F G
ENTER
[TEST TONE]
F G, ENTER D H
Setting the Auto Surround Mode
Set whether or not to store the surround mode last played for the
input signal.
The surround mode used at last for the three types of input signals
shown below is stored in the memory, and the signal is automatically
played with that surround mode the next time it is input.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals of Dolby Digital, DTS or other multi-channel
format (DOLBY PL II x Cinema)
e Multi-channel signals of Dolby Digital, DTS or other multi-
channel format (DOLBY/DTS SURROUND)
Default settings are indicated in ( ).
Press ENTER to enter the setting and switch to the
Speaker Setup.
2
Press F F G G to set. 1
1 2 A u t o S u r r . O F F
1
2