3DLABS Wildcat4 7110 - Manual (Page 18)

Software Configuration
NOTE: If setup is not able to find 3ds max in the system registry, it will not install the
driver and will exit. Consult your 3ds max application's documentation to verify
that the application is installed correctly. The driver setup program will only install
for a registered application.
Verify the Default Video Display Driver
Verifying under Windows 2000
1. From the Windows Start menu, go to Settings/Control Panel/Device Manager.
2. Under Display Adapters, verify that two Wildcat devices are listed. This indicates that the
appropriate driver is installed.
NOTE: If only one Wildcat4 device is listed, you may not have completed installation.
Refer to “Installing the Driver Software” for instructions.
3. Click Cancel to close the Display Properties dialog box.
Verifying under Windows XP
1. From the Windows Start menu, go to Control Panel/Performance and Maintenance/ System
Hardware/ Device Manager.
2. Under Display Adapters, verify that two Wildcat devices are listed. This indicates that the
appropriate driver is installed.
NOTE: If only one Wildcat4 7210 device device is listed, you may not have completed
installation. Refer to “Installing the Driver Software” for instructions.
3. Click Cancel to close the Display Properties dialog box.
Verify the System Startup Version
Verifying under Windows 2000
1. From the operating system Start menu, go to Settings/Control Panel/System/Advanced.
2. Click Startup and Recovery.
3. On the Startup and Recovery dialog box, verify that "Microsoft Windows 2000
Professional" is the listed as the Default operating system. It is IMPORTANT that your
operating system matches the driver you installed. Click OK.
4. Click OK again to close the System Properties dialog box.
3Dlabs Graphics Accelerator Card User's Guide 14