DuPont Authentication Velpar L H - 63377 - Manual (Page 16)

NON-AGRICULTURAL USES
APPLICATION INFORMATION
VELPAR L is recommended for general weed and brush control
in noncrop sites such as railroads, highways, utility and pipeline
rights-of-way, petroleum tank farms, storage areas, industrial
plant sites, and other similar areas.
VELPAR L is recommended for control of many annual,
biennial, and perennial weeds in noncrop, industrial sites.
APPLICATION TIMING
Apply VELPAR L as a preemergence or postemergence spray
when weeds are actively germinating or growing.
WEEDS CONTROLLED - USE RATE
VELPAR L effectively controls the following weeds when
applied at the use rates shown. When applied at lower rates,
VELPAR L provides short-term control of the weeds listed;
when applied at higher rates, weed control is increased and
extended.
1–2 1/2 Gal/Acre
3–4 Gal/Acre
* Partial control
† Partial control may result with some of the giant (larger) smutgrass species.
SPECIFIC WEED PROBLEMS
Control of Canada Thistle in Crown Vetch - VELPAR L is
recommended for control of Canada thistle in established stands
of crown vetch on noncrop sites. Make a single application of
3–5 pt of VELPAR L from late spring through mid-summer,
when thistle is actively growing prior to flowering. Do not use a
surfactant. Some discoloration of the crown vetch foliage may
occur after application.
SPRAY EQUIPMENT
Apply VELPAR L uniformly over the desired area using ground
equipment only.
MIXING INSTRUCTIONS
For ground application, use enough water for thorough
coverage, usually a minimum of 25 gal per acre. Higher
application volumes may be needed to obtain uniform
application with handgun equipment.
VELPAR L is recommended for selective weed control in
established stands of bermudagrass and/or bahiagrass in noncrop
areas.
APPLICATION TIMING
Make a single application of VELPAR L per year when weeds
are actively growing.
WEEDS CONTROLLED - USE RATE
VELPAR L effectively controls the following weeds at the rates
shown. Use a lower rate on coarse-textured soils (sand to sandy
loam). Use the higher rate on fine-textured soils (clay loam to
clay) and on soils high in organic matter.
2 3/4–4 1/2 pt
† Partial control may result with some of the giant (larger) smutgrass species.
Barnyardgrass
Dogfennel
Fescue
Lespedeza
Little barley Maypop (passion flower)
Oxalis
Pepperweed
Pigweed
Smutgrass
†
INDUSTRIAL TURF (UNIMPROVED ONLY)
Bahiagrass*
Bermudagrass*
Blackberry
Bluegrass
Broomsedge
Camphorweed
Canada thistle*
Chickweed
Clovers
Dewberry
Dogfennel*
Fescue*
Fingergrass
Foxtail Guineagrass
Heath aster
Honeysuckle
Lantana
Marestail
Natalgrass
Plantain
Prickly lettuce
Ragweed
Smutgrass
†
Spanish needle
Vaseygrass
Wild carrot
Barnyardgrass
Bindweed*
Bouncingbet*
Bromegrass
Buffalograss*
Burdock
Cocklebur
Crabgrass
Crown vetch
Curly dock*
Dandelion*
Dogbane*
Fiddleneck
Filaree
Fleabane
Goatsbeard vine
Goldenrod Lespedeza
Milkweed*
Mustard
Nutsedge*
Orchardgrass*
Oxalis
Paragrass
Pigweed
Purslane
Quackgrass
Ryegrass, annual
Smartweed
Spurge
Star thistle
Trumpetcreeper*
Wild oats*
Wild parsnip
NONCROP, INDUSTRIAL SITES
NON-AGRICULTURAL USE REQUIREMENTS
The requirements in this box apply to uses of this
product that are NOT within the scope of the Worker
Protection Standard for agricultural pesticides (40 CFR
Part 170). The WPS applies when this product is used to
produce agricultural plants on farms, forests, nurseries,
or greenhouses.
Industrial and Pasture/Rangeland weed and brush
control applications as described on this label for
DuPont VELPAR L are not within the scope of the
Worker Protection Standard.
The area being treated must be vacated by unprotected
persons.
Do not enter or allow entry into treated areas until sprays
have dried to perform hand tasks.
14