3DLABS Oxygen VX1 - Manual (Page 27)

The Oxygen VX1/Oxygen GVX1 Driver
18
Monitor Screen
This page allows Windows NT users to specify a monitor type and display the available
settings, but it does not permit the actual selection of different monitor modes. To select
modes, click the Settings tab at the top of the Display Properties panel.
When you open the Display Properties panel and the DDC button is selected, your system
automatically checks whether it is connected to a DDC-type monitor. If so, the available
modes will be displayed. It is possible, however, for the display settings to fall out of
synchronization. This can happen, for example, if you hot-swap monitors. The Detect DDC
monitor button lets you manually tell your system to look for the DDC monitor again.
The Type section shows which type of monitor was detected when you opened the control
panel, and allows you to select a different type if desired. The Monitor Information section lists
supported monitors. If your monitor is shown in this list, select Specific Type in the Type
section. If your monitor does not appear in the list and is not a DDC-type monitor, select
VESA.