Accutone WT99 - Manual (Page 4)

[ inspiring people, inspiring change ]
Installation Installation
A. Setting up Headset
WT99 WIRELESS TELEPHONE HEADSET
your true wireless handsfree office solution!
The headset is composed of three parts: the Headset Body, the Headband
and the leatherette Ear Cushion. Assemble them together as shown below
before you proceed further.
Headset Body
Headband
Ear Cushion
First connect the headband to
the headset body by pusing the
knob through the hole, you
should feel a “click” sound as
firmly connected.
Secondly, connect the ear
cushion to the headset body in a
similar fashion until you can feel
the same “click” sound.
1 2
Ear Cushion
Headband
Headset Body
B. Connecting to Telephone
Unplug the handset from your telephone
base, and plug the handset into the
Handset Connector
.
Connect one end of the RJ Modular Cable
to the Telephone Connector
under the base station, the other end of
the RJ Modular Cable
goes into the
handset jack of your telephone unit
(where it used to connect to the
telephone handset).
Connect the Power Adaptor to the
Power Adaptor Jack , then connect
to any power socket. (Make sure the
voltage specified on the adaptor
corresponds to your local electrical
power supply specifications.)
The power adaptor may come with
country-specific pin-adaptors, select the
one that fit the standard power socket of
your country. Simple install the adaptor by
facing the metal pins on the power
adaptor to the socket on the pin adaptor.
*Place the base station at least 15cm away
from the telephone to avoid interference.
(18)
(X) (17)
(Y)
(P)
(15)
X
Y
!
16
15
17
18
P
5 6