Acrosser AIV-HM76V1FL - Manual (Page 11)

AIV-HM76V1FL Series User Manual
11 www.acrosser.com
Status/HDD/Power LED Display
LED Light Display
G Green Status
G Green HDD
Y Yellow Power LED
Status LED Flashing Status:
A Status LED is used to indicate the status of the system. In normal condition, the
LED will flash a number of blink to state the status. Each blink remains 200 ms ON
followed by a 200 ms OFF. Each Cycle will have a 2-second OFF in between.
LED Flashing
Numbers
Status
0 (Constant On) Power output runs normally.
1 Standby Mode (System off)
3 Power On Delay
5 Boot Up Delay
6 Soft Off Delay
4 Shutdown Delay
2 Hard Off Delay
If abnormal condition occur, the LED will flash a 1.5-second pulse followed by
numbers of 200 ms pulse to indicate the error status.
LED Flashing
Numbers
Error Status
1 Long, 1 Short
System cannot be turned on or was turned off because
battery voltage is below the Battery Low Voltage.
1 Long, 2 Short
System on/off fail. When motherboard cannot turn on or turn
off after retry.