Db_e9-10, Peaker connections, Emote bass control module – DB Drive Speed Series Amplifier SPA SPA90.2 User Manual

Page 6: Power, Included

Advertising
background image

9

10

S

PEAKER CONNECTIONS

(SPA90.2 , SPA90.4 , SPA150.4)

Make the speaker connections using speaker wire that is at least 16

gauge or heavier.

As with any audio component, proper phasing of the amplifier and speakers is essential

for strong bass response. When connecting, make sure that positive (+) from the amplifier

is connected to the positive (+) of the speaker, and the same for negative (-).

***

CAUTION! In the bridged mode, the amplifier must see a 4 Ohm load or higher. Any

lower than 4 ohms will cause the amplifier to overheat and possible cause permanent

damage to the amplifier!

R

EMOTE BASS CONTROL MODULE

(SPA1000D, SPA1300D, SPA1600D, SPA1900D

Included

)

Before connecting the remote, it will be necessary to find a mounting location that will be

easy to access for adjustment. Once you select your mounting location, you will need to run

the control wire from the remote to the amplifier. To avoid possibility of induced noise from

the car’s electrical system (i.e. popping noises or engine noise), run the cable from the

remote to the amplifier away from the car’s electrical wiring.

speaker output

power

fuses

rem gnd

+12v

protect

(-) ------ bridged ------ (+)

R (-) R (+) L (-) L (+)

ch4- ch4+ ch3- ch3+ ch2- ch2+ ch1- ch1+

speaker output

power

fuses

protect

rem

gnd

+12v

(-) ---- bridged ---- (+) (-) ---- bridged ---- (+)

speaker output

power

fuses

rem gnd

+12v

protect

(-) ------ bridged ------ (+)

R (-) R (+) L (-) L (+)

+

-

+

-

+

-

+

-

+

-

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

4 Ohm Speaker

ch4- ch4+ ch3- ch3+ ch2- ch2+ ch1- ch1+

speaker output

power

fuses

protect

rem

gnd

+12v

(-) ---- bridged ---- (+) (-) ---- bridged ---- (+)

freq

x-over

input

level

input

bass

boost

0dB 18dB

bass

boost

0dB 18dB

60Hz 400Hz

freq

60Hz 400Hz

low full high

x-over

remote

low full high

ch 1

ch 3

ch 2

ch 4

min max

input

level

min max

spa90.4

classAB 4 channel amplifier

POWER

Min

Max

+

-

+

-

+

-

-

+

Advertising