Atx and at power configuration – Acrosser AR-B5230 User Manual
Page 25
Advertising
AR-B5230 Series User’s Manual
25/25
ATX and AT POWER CONFIGURATION
J1 (SPEAKER, RESET, and POWER BUTTON JUMPER Setting)
When using an AT power supply in your system, the pin5-6 of header J1 must be shorted. If
using an ATX power supply in the system, the pin5-6 of header J1 should connect to a
Push-Button-Switch.
NOTE: When a system using AT power supply, the monitor will not display any
message and the system will not auto-shut down after soft-off. In this case, please
push the power switch to cut the system power off.
Advertising