Dual MDM300 - Manual (Page 6)

6
MDM300 OPERATION
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push
left side to secure.
Press or any other button (except EJECT) to turn the unit
on. Press to turn the unit off.
Press MODE to select between AM/FM, CD player, auxiliary,
USB and SD card. Modes of operation are shown in the
display.
NOTE: CD, SD and USB modes will not appear unless a CD,
SD Card or USB device is inserted.
The MDM300 a 3.5 mm auxiliary input port on the front panel
of the unit for connecting an audio device, MP3 player, etc.
Press MODE to select auxiliary input mode.
Adjust volume using volume knob (0-47).
Press LOUD to activate the Loudness function. Activating
Loudness will enhance the bass and treble frequencies
when listening to music at low volumes.
Press DISP to show the clock. During playback of MP3/WMA
files, ID3 tag information, elapsed time, track number and
file/folder names will automatically alternate on the display.
Press RESET upon initial installation or if abnormal
operation occurs. Reset button is located behind the front
panel.
With the unit on, press and hold DISP until the clock begins
to flash, then release. Turn the volume knob to the right to
adjust the hours or to the left to adjust the minutes.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10.00). In European frequency spacing
mode, the clock will display 24-hour time (22.00).
Press and hold the volume knob for more than 3 seconds
to access the setup menu. Press volume knob momentarily
to select between the menu functions and rotate the volume
knob left/right to adjust or activate the desired function.
Faceplate Removal
Power On/Off
Mode
Auxiliary Input
Volume
Loudness
Display
Reset
Set the Clock
12/24-hour Clock
Setup Menu
General Operation