ADLINK IMX-3000 - Manual (Page 53)

IMX-3000
53
Mode Enable Hands Free Disable Hands Free
Ignore same
code
Press the Scan button, then
release it. Align the aiming beam
with the barcode to scan the
barcode.
The scan engine will trigger
continuously at 2 second
intervals. In this mode, repeated
barcode data will be ignored. Press and hold the Scan button.
Align the aiming beam with the
barcode to scan the barcode.
The scan engine will trigger
continuously at 2 second
intervals. In this mode, repeated
barcode data will be ignored.
Stop when
success
Press the Scan button, then
release it. Align the aiming beam
with the barcode to scan the
barcode data.
The scan engine will trigger
continuously at 2 second
intervals. The scan engine will
stop triggering after barcode
data has successfully been
scanned. Press and hold the Scan button.
Align the aiming beam with the
barcode to scan the barcode
data.
The scan engine will trigger
continuously at 2 second
intervals. The scan engine will
stop triggering after barcode
data has successfully been
scanned
Continuous mode
Delay for
same code
Press the Scan button, then
release it, the aiming beam will
continuously trigger. Align the
aiming beam with the barcode to
scan the barcode data.
The scan engine will stop
triggering for 0.5 seconds after
successfully scanning barcode
data. In this mode, scanning will
not stop until the Scan button is
pressed again. Press the Scan button, then
release it, the aiming beam will
continuously trigger. Align the
aiming beam with the barcode
to scan the barcode data.
The scan engine will short stop
triggering for 0.5 seconds after
successfully scanning barcode
data. In this mode, scanning will
not stop until the Scan button is
pressed again.