Advanced Control Technologies Specs Instructions ZTH210 (RF Controller, HandheldLED Indicator, 868.42MHz) - Manual (Page 4)

ZTH200 Operating Instructions (Version 1.26)
P/D 102406 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
4
WIRELESS CONTROLLER
This user manual is designed to guide
you through the setup and features of
the HomePro Z-Wave Lighting and
Appliance Control System. You will be
amazed at the possibilities for control.
You can easily enhance the comfort and
security of your home or office. You’ll
see how easy it is to quickly create a
totally customized system that can
remotely control lamps and appliances
without costly professional installation...a
system that any do-it-yourself person
can easily handle.
For example, with just one Wireless
Controller you can control up to 64
individual lamp units or wall switches!
You can control a single receiver, in
groups, or all receivers at once. You can
turn on custom programmed mood
lighting and use timers for lighting as a
burglar deterrent.
This user guide tells you how to create
your system. Instructions for installation
and setup of built-in components (wall
switches, dimmers, etc.) are included
with those components.
The HomePro Z-Wave Lighting and Appliance Control System
gives you the following functionality.
Safety and Security
•
All OFF/ALL ON
On the way out you can turn off all lights in the house with one button.
At night, if you hear noises, you can turn all lights in the house on from
your bedroom.
•
Timers
Let the clock control your lamps and appliances so they automatically
turn on and off at preset hours. You won’t ever have to come into a
dark house again.
Comfort
•
Remote Control
Control your lights wirelessly from the sofa, the bed, the kitchen or
wherever you are.
•
Grouping
No more wandering from lamp to lamp. Control groups of lamps
simultaneously with one button.
•
Scenes
Create and save custom lighting scenes for special occasions like
dinner parties, TV watching, romantic atmosphere, book reading, etc.
•
Dimming
Dimming lights with the HomePro Control System saves on electric
bills.
•
Thermostat Control
Switch from Heating to Cooling modes and adjust setpoint from your
easy chair.
RF Home Automation
Full Coverage plus added communication with Version 1.26
One of the key features of the HomePro Z-Wave is the fact that Z-Wave automatically routes the signal from one device to the next,
effectively going around obstacles and radio dead spots in your home or office. You only need to be within 100 feet of any HomePro
Z-Wave device to communicate with all other HomePro Z-Wave devices, so the more HomePro Z-Wave enabled devices you have
in your home or office, the better the coverage and the more reliable the network becomes.
New software features (Version 1.26) allow changing the factory configuration of devices and reviewing the settings. In addition it
allows association of a device with other specific devices and a review of those associations. The software version of any
HomePro ZTH200 can be verified by going to: Setup Menu/Reset Remote Control/Factory Default/press ALL LIGHTS OFF button.
The ZTH200 allows most devices into a group so they can be controlled by the remote. The device types that will specifically not
be added to a group (though they will be added to the Z-Wave system) are the following: Thermostat Controller, Repeater Slave,
Binary Sensor, Multilevel Sensor, Pulse Meter, Entry Control and Non Interoperable.
The types listed above will not be controlled by the remote because they either have nothing to control or do not support the BASIC
COMMAND which the remote uses to turn devices on and off. Device ID is shown when the device is added to the network.