Advanced Control Technologies Specs Instructions ZTW103I (RF 120 VAC, Wall Transmitter,908.42MHz, Ivory) User Manual

Page 6

Advertising
background image

ZTW103 Advanced Instructions, Release 1.1
P/D 102406

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.

0728-01

6

SPECIFICATIONS

Power

120 VAC, 60 Hz

Signal (Frequency)

908.42 MHz

Range

Up to 100 feet line of sight between the Controller and /or the closest HomePro
Receiver Module

INTEROPERABILITY WITH Z-WAVE™ DEVICES

A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different
manufacturers. The ZTW103 can be incorporated into existing Z-Wave™ networks.

The top or bottom of the paddle on the face of the ZTW103 can be pushed to carry out inclusion, association, or
exclusion.

WARRANTY

For warranty and general product information visit our web site at www.act-solutions.com

ABOUT ZTW103’S CERTIFICATION

The ZTW103 is certified to comply with applicable FCC and IC
rules and regulations governing RF and EMI emissions.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interfer-
ence received, including interference that may cause undesired
operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.

IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.

Advertising