American Energy Systems MF3540 Fuel Stirrer Motor - Manual (Page 2)

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3540 Fuel Stirrer Motor.doc
• Position fuel stirrer motor and tighten loosely. Keep screws loose until chain is in place
using hardware listed above.
• Place MF3517 fuel stirrer sprocket
on the fuel stirrer motor shaft.
Ensure set-screw is lined up on the
flat part of the motor shaft.
• Tighten sprocket on shaft.
• Place fuel stirrer chain on the
fuel stirrer motor sprocket and
tighten (4) bolts on the motor.
Tighten bolts as shown
allowing 1/8” compression on
the gasket (MF3578)
• Check chain tension by
pinching center of the chain
together with normal finger
pressure. Ensure this is a
3/16”-7/32” space between
both halves of the chain.
• Tighten 4 bolts
• Plug back into power supply.
1
2
3
4