American Sanders CE7 & Pro Edgers - Manual (Page 7)

EN ENGLISH
Clarke ® American Sanders Operator's Manual (EN) - CE7 Pro, SE7 Pro, CE7 Pro+, SE7 Pro+ - 7 -
Figure 1.1
Figure 2.1
Figure 2.2
7" Hook and Loop
MACHINE SET-UP
Fig. 1.1 OPERATING HANDLE
The operating handle provides control and comfort to the sanding
experience (all models). On models 07170A and 07176A, the handles
may be set to a greater height depending on preference. Remove the
4 screws securing the handle to the machine. Raise the handle until
the holes align then reinstall the 4 screws.
Fig. 2.1, 2.2 Abrasive Driver
The unit will accept either 7” hook and loop or 7”x7/8” center
hole abrasive disc. Motion is delivered to the abrasive through a
replaceable spring steel sanding disc (11226A) having a medium hook
surface (39864A). The unique geometry provides a flat finish and
smooth sanding experience, reducing objectionable scratches. The
unit is equipped with a retaining screw, washer, and onboard wrench
for use with 7” x 7/8” abrasive. When installing abrasive disc, take
care to center disc on driver.
NOTE: When using 7” x 7/8” abrasive, hold the sanding disc while
tightening the retaining screw. Do not over tighten or removal will be
difficult.
To avoid injuring the hook surface on the driver when sanding thick
paint, varnish or wax, it is recommended you stack two discs on the
driver using a course open coat abrasive.
7" x 7/8" Mounting Hole