Warning, Setup requirements – Angelcare AC300 User Manual

Page 4

Advertising

IMPORTANT
Place the crib near a supporting wall and
far from air currents. Install the Nursery
Unit on a flat, stable surface facing the crib
at a distance of at least 1 meter.

YOU MUST PREPARE:

One hardboard (not included)
Thickness:

6 mm

Minimum dimensions:
33 cm x 33 cm
Maximum dimensions:
equal to the mattress size

WHAT YOU WILL NEED (NOT INCLUDED):

Nursery Unit

1 Sensor Pad (AC300) or

2 Sensor Pads

(AC300-2SP)

with pre-installed cord covers

Hardboard

MOVEMENT MONITOR

Model AC300

Miniature Philips

Screwdriver

IMPORTANT
The hardboard must be larger than
the Sensor Pad surface area or in
the case of the AC300-2SP of two
Sensor Pads.

BABY’S ROOM:

SETUP REQUIREMENTS

2 AA Alkaline

Batteries

INCLUDED:

STEP 1 - INSTALLING THE SENSOR PAD

WARNING

STRANGULATION HAzARD.

Children have been STRANgLED by cords.
• NEVER use Sensor Pad (s) without the protective

cord covering.

• Because of the serious strangulation risk to infants

and toddlers, parents and caregivers should never

place the Nursery Unit within 1 m of a crib.

•

NEVER use Sensor Pad without the cord covers.

Check cord covers before each use to ensure it is

securely placed under the leg of the crib. Discontinue

use of Sensor Pad if any cord covers are damaged or

broken.

Cord covers 1, 2, 3, 4:
Position on floor

Cord cover 4:
Contains double sided
tape to securely install
beneath crib leg

Cord cover 5:
Position vertically
between mattress
support and floor

Cord cover 6:
Place under
the mattress

Sensor Pad with pre-installed cord covers

1.1 - SELECT A LOCATION FOR THE NURSERY UNIT

Select a location for the Nursery Unit that is
at least

1 meter away from the crib.

Keep

at least

1 m

IMPORTANT

Sensor Pad