SoundMax SM-CDM1068 - Manual (Page 9)

9
Function of controls
General operations
Reset the unit
Operating the unit for the first time or after replacing the car battery, you must reset the unit.
Press OPEN button and remove the panel, then press the RESET button to restore the unit to the original
factory settings.
Power button
Press any button except the OPEN button and EJECT (EJ) button to turn the unit on.
Press the PWR to switch the unit off.
Note: After the unit is off, the clock, volume level and radio current settings will be memorized, and when
you turn the unit on it will resume the stored status which you set.
Volume mode
Press SEL button shortly and repeatedly to select sound mode VOLUME, BASS, TREBLE, BALANCE, FADER.
Press + or - button to adjust level of the selected sound mode:
- VOL: 00, 02,......, 44, 46
- BASS/TREB: -6, -5,......, 0, +1, +2,......+5, +6
- BAL: 12L, 11L,......, L=R, 1R,......,12R
- FAD: 12R, 11R,......, R=F, 1F,......, 12F
NOTE: Adjustments to Bass and Treble will override any preset EQ (Preset Equalizer Curves).
In each mode, the waiting time is about 5 seconds, and the waiting time is over, it returns to the last display
mode of radio or disc playback mode.
Menu mode
Press the button SEL and hold more than 2 seconds to enter menu mode, then press SEL button shortly and
repeatedly to select: EQ, CLK FORMAT, TIME, AREA, VOL PGM, BEEP, CLK ON LCD in the sequence and
circulation. After select the desired mode, press + or - button shortly and repeatedly to select the mode of
the selected item.
EQ: Press the +/- button to adjust the EQ mode as follows: EQ OFF, FLAT, CLAS, ROCK, POP.