Drolet HT1200 - Manual (Page 5)

ASSEMBLY
PEDESTAL AND DECORATIVE SIDEWALL INSTALLATION
Figure 1: HT-1200 Deluxe
Pedestal Installation :
1. Remove all bricks and insulations in
the appliance.
2. Slowly, lay down the stove on his
back.
3. Install legs or the pedestal with the
supplied nuts and bolts. Stand up
the stove and place it with the
required clearances. Note that
there is eight holes in the bottom of
the stove but only four will align with
the pedestal.
4. Slide the front part of the pedestal
base around the pedestal and fix
the rear part with the two supplied
screws.
5. Slide the ash pan in position (for
Deluxe model only).
Figure 2: HT-2000 Deluxe
Side Panels Installation :
1. Fix the front part of the decorative
side with two screws supplied. The
oblong holes allow to adjust the
height of the side 3\16" (5 mm)
above the top of the stove.
2. Then, fix the back on the decorative
side with three screws and washers
supplied. Line up the decorative
side in relation to the side of the
appliance.
4