Bonaire Home Automation (Touchpad Only) - Manual (Page 3)

O WNER ’ S M ANUAL
Home Automation
Page 3
Setup
The interface module has been supplied with a 1 metre comms connection cable.
•
Connect the interface module cable into the comms port on the unit control board.
•
Connect the Touchpad 20 metre comms Touchpad loom into the plug on the
interface module.
•
Connect the home automation wires to the screw terminals as per the wiring diagram
below.
•
Connect the 9V AC power pack out put plug to the interface module.
•
Plug the 9V AC power pack into a 240-volt supply and power up.
•
Power up the Climate Technologies product being interfaced. A red status light will
indicate product signal status through the interface.
•
Once the Climate Technologies product has initialised with the Touchpad, use the
home automation device to test turning the product ON or OFF.