Bonaire / Celair (Tekelek) - Manual (Page 16)

LP SERIES OWNER’S MANUAL
Controls Setup & Commissioning
TEK600 SERIES CONTROL Page 16
M ANUAL W ALL C ONTROL – S ETUP O PTIONS
Dump Valve
A dump valve can be fitted when using
a manual control with limited function.
•
There is no dumping cycle or delay
time function available.
•
The water will dump each time the
COOL switch is turned OFF.
•
Water bleed off will be required
Multiple Unit Connection.
The manual control can only control
ONE air conditioning unit.
Minimum / Maximum Speed Adjustment.
TIPS: Read the below instructions 1 to 5 before entering the minimum speed control
mode. If the user takes to long to enter information into the wall switch the control will
time out and the user will have to start back at instruction number 1.
1. Ensure the fan and cool buttons are in the off mode and the speed control dial is set
to the maximum position (fully clockwise).
2. Rotate the speed control dial to the minimum position (fully anti clockwise), wait three
seconds then press the cool button once.
3. Rotate the speed control dial back to the maximum position (fully clockwise), wait
three seconds and press the cool button once.
4. Rotate the speed control dial back to the minimum position (fully anti clockwise) and
press the fan button once.
5. The fanlight will flash in a dull and bright sequence to indicate that the minimum
speed selection has been made and the fan motor will start in the low speed mode.
6. By adjusting the dial, the minimum speed can be selected. Rotate the dial to the
desired minimum speed, then press the cool button to set the maximum speed (go to
step 7) or press the fan button to complete minimum speed adjustment.
*NOTE: Do not set the minimum speed to low, as this will cause the motor to burn
out. Optimum minimum speed RPM should be between 500 and 650 RPM.
7. After the cool button has been pressed the fan light and cool light will both be
flashing a dull and bright sequence to indicate maximum speed adjustment has been
made and the fan motor will increase in speed. By adjusting the speed control dial a
maximum speed selection can be made.
Once the maximum speed has been selected press the fan button once then press
the cool button once.
TIPS: once the minimum and maximum speeds have been selected always press
the fan button first then the cool button. If the cool button is pressed first then the fan
button, the control will enter a new minimum speed setting that may be incorrect for
the units operation.
8. The wall switch at this point should be in the off mode, press the fan button once to
start the fan and confirm minimum and maximum speed settings.