Chicago Gaming Medieval Madness Remake User Manual
Page 45
The Sound and Music test checks the audio cir
c
uits
.
This tes
t
has three modes for test
i
ng the
sound and music circuits -
-
Run
,
Repeat,and Stop.
T.6 GENERAL ILLUMINATION TEST CONTINUED...
Run: The Run mode cycles through the General Illumination test automatically.
For
each circuit shown in the d
i
splay the correspondi
n
g
LEDs should light. I
f
any
other results occur, the system has detected a problem. To return to the Test
menu, press
the Escape button. To returnto the Stop mode
,
press the Enter button.
T.7
SOUND AND MUSIC TEST
Stop: The Stop mode stops this test altogether. Nothing should be heard. Any other
results indicate the system has detected a problem. To return to the Test menu, press
the Escape
button
.
To returnto
t
he Run mode, press the Enter
button.
Repeat:
The Repeat mode causes the program to stop and repeat a particular
sound/tune
.
The same sound repeats continuously until you press the Up or Down
buttonsto advance to the next one. Any other resul
t
s ind
i
catesthe system has detected
a problem
.
To returnto the Test menu
,
press the Escape
button. To advanceto the
next
test mode, pressthe Enter button
.
Run: The Run mode steps th
r
ough a sequence of sounds and music
.
Press the Up or
Down buttons to advanceto a particu
l
ar sound or tune. A sound or tune should be heard
for each name and number that appears in the display
.
Any other results ind
i
cate the
system has detected a problem
.
To return to the Test menu
,
press the Escape button
.
To advanceto the next test mode, press the Enter
button.
T.8 SINGLE LAMP TEST
T.9
ALL LAMPS TEST
T.10 LAMP AND FLASHER TEST
T.11 DISPLAY TEST
The Single Lamp tes
t
checks each lamp circuit
i
ndividually
.
Press the Up or Down buttons to
scroll through this test. A lamp should light for each name and number that is displayed. Any
other results indicate the system has detected a problem. To return to the Test menu
,
press the
Escape
button
.
This test causes all the controlled lamps to flash at the same time
.
Every controlled lamp should
flash
.
Any other results indicate the system has detecteda problem. To return to the Test menu
,
press the Escape
button.
This test causes all the flashlamps and the controlled lamps to flash at the same time. The
controlled lamps blink, while the flashlamps cycle from highest to lowest. Any other results
indicate the system has detected a problem
.
To return to the Test menu, press the Escape
button.
.
This test automatically checks every dot in the Dot Matrix Display board
.
A series of patterns
appear in sequence
.
Each pattern turns on and off a section of dots. Every do
t
on the matrix
display should be turned on and off during this tes
t.
To return to the Test menu
,
press the
Escape
button.
1-
21