Cino A770 HC User Manual

Page 6

Advertising
background image

5

Force Mode

When force mode is selected, the light source of the scanner is forced on for
continued operation without having to press the trigger switch. This mode is
convenient for high speed bar code reading.

Toggle Mode

When toggle mode is selected, you must press the trigger switch to turn on
the light source of the scanner to start scanning operation. The scanner
keeps the light source on until you press the trigger switch again. This mode
is very similar to alternative mode but without the preset light source on time
concern.

Diagnostic Mode

When diagnostic mode is selected, the light source of the scanner is forced
on without regard for other programmable parameters, such as reread delay,
redundancy, and so on.

Low Power Mode

When low power mode is selected, the scanner goes into idle state after
scanning the bar code. You must press the trigger switch to wake up the
scanner for operation.

Multiple Read Mode

When multiple read mode is selected, the scanner is allowed to decode
multiple bar codes with a single pull of the trigger. When you press and hold
the trigger to aim at a series of bar codes, the scanner will decode each bar
code and beep for each good read. For more precise bar code decoding, you
are recommended to enable Center Alignment function while multiple read
mode is selected. You also can enable Unique Bar Code Reporting function
to report only unique bar code when the scanner trigger is pressed. For the
setting of Center Alignmen and Unique Bar Code Reporing, please refer to
Programming Manual for details.

Advertising
This manual is related to the following products: