Cino A770 HC - Manual (Page 74)

F
u
z
z
y
S
c
a
n
P
ro
g
ra
m
m
in
g
M
a
n
u
a
l
Configure Your FuzzyScan
67
PROGRAM
Operation Control
(All Series)
♦ ♦ ♦ ♦ Light Source On Time, Hands Free Time-out ♦ ♦ ♦ ♦ F_DEFAULT
Family Code Selection P.C Parameter Selection Option Code
Light Source On Time
SS
SS
SS
SS Short
Medium
Long
Extremely long 0
1
2
3
Hands Free Time-out
SS
SS
SS
SS
SS Short
Medium
Long
Extremely long
Disable 0
1
2
3
4
Good Read Duration
SS
SS
SS
SS
SS Short
Medium
Long
Extremely long
Extremely short
0
1
2
3
4
Time Delay to Low Power Mode
SS
SS
SS
SS
SS
SS 1 sec
3 secs
5 secs
7 secs
9 secs
Immediate 0
1
2
3
4
5
The Light Source On Time is a pre-defined light source time out counter for Alternative Mode, Presentation Mode and Level Mode. The scanner keeps the light source on
till the pre-defined light source on time is up. You can adjust this parameter to meet your own application requirement.
The Presentation Mode, Force Mode and Flash Mode are referred to as “hands free” mode. The hands free mode will be automatically changed to manual trigger mode
when you press the trigger. You can remain the scanner in manual trigger mode by setting the Hands Free Time-Out. Once the time-out duration is up (if there’s no any
trigger operation), the imager will revert to the original hands free mode.
The Time Delay to Low Power Mode sets the time for scanner to enter low power mode after any scanning activity. This setting is only available for the scanner is in low
power mode.