Cino SM5700 User Manual
Page 62
F
u
z
z
y
S
c
a
n
O
E
M
S
c
a
n
M
o
d
u
le
P
ro
g
ra
m
m
in
g
M
a
n
u
a
l
57
PROGRAM
Operation Control
SM5700
♦
♦
♦
♦
Operation Control,
Presentation Background lighting Control
♦
♦
♦
♦
F_DEFAULT
Family Code Selection
P.C
Parameter Selection
Option Code
Operation Mode
SS
SS
SS
SS
SS
Trigger mode (External triggering)
Presentation mode (Auto detection)
Alternative mode (Periodic power off)
Force mode (Continued power on)
Level mode (Auto power off)
1
2
3
4
7
Presentation Background Lighting
SS
SS
LEDs Off
LEDs On
0
1
Trigger Mode (External Triggering) When the scan module receives an external trigger or a serial trigger ON command under trigger mode, the scan module will turn on
the light source to read barcode until gets a good read, a serial trigger OFF command or a release of external trigger. Once the light source goes off, the scan module
is waiting for the next trigger to activate scanning again.
Presentation Mode (Auto Detection) When presentation mode is selected, the scan module is preset to turn on the background lighting to detect the barcode. Once the
scan module detected a similar barcode image, the scan module will turn on the light source to read barcodes until the preset scan input time-out is up. For dark
environments, you may adjust the setting of “Presentation Sensitivity” to increase the detection sensitivity
Alternative Mode (Periodic Power Off) When the scan module receives an external trigger or a serial trigger ON command under alternative mode, the scan module will
turn on the light source to read barcodes until the preset scan input time-out is up. The scan input time-out will be reset after each good read. Once the light source
goes off, the scan module is waiting for the next trigger to activate scanning again.
Force Mode (Continued Power On) Under force mode, the scan module continues to read barcodes without using external trigger or serial trigger. Please note that the
scan module will not stop reading until you switch into another operation mode.
Level Mode (Auto Power Off) When the scan module receives an external trigger or a serial trigger ON command under level mode, the scan module will turn on the light
source to read barcodes until a good read is performed or the preset scan input time-out is up. Once the light source goes off, the scan module is waiting for the
next trigger to activate scanning again.
Hand-Free Mode: Presentation mode, Force mode
Presentation Background Lighting Control: You can enable or disable presentation background lighting of the scan module according to the ambient light condition in
presentation mode. When the ambient light is dim or dark, you can enable this function to turn on the scan module’s LED illumination at a dim level. This is helpful for scan
module to detect the motion of scene.