ClassCo PSM585 Emergency Notification Device - Manual (Page 9)

Setup Options
You can customize the way your PSM585 works. Hold down the MODE key and
momentarily press the PROGRAM key to enter SETUP MODE. You can change
the option by pushing the PROGRAM key, and can go to the next option by
pressing the MODE key.
RESET – Pressing PROGRAM will cause the unit to enter factory reset state,
clearing memory, displaying software version, performing a memory test and
displaying results.
ENGLISH -- ON/OFF (Factory ON) Switches English language ON or OFF for
all display and announcement functions.
MSG WAIT BEEP -- ON/OFF (Factory OFF) Unit beeps to as audible alert to
message waiting (voice mail) indicator
CW CATEGORY – ON/OFF (Factory OFF) Announces only category, or
Number Unknown, or Number Blocked for call waiting callers.
SDT DETECT – ON/OFF (Factory OFF) Detects stuttered dial tone for
message waiting indication.
EAS ANNOUNCE -- ON/OFF (Factory ON) Announces Public Safety Notice
corresponding to the received EAS code in Safety messages.
DEVICE ALARM – ON/OFF (Factory ON) Chirp sounds when Telephone
service or AC power is lost, or battery is low.
NEW INFO ALERT – ON/OFF (Factory ON) Chirp sounds to indicate new
PSM Informative messages.
NEW MSG ALERT -- ON/OFF (Factory OFF) Chirp sounds after any new
message is received
CWID DETECT -- ON/OFF (Factory ON) Enables/Disables Caller ID with Call
Waiting feature (requires applicable caller ID services)
Troubleshooting
Having problems? Before contacting ClassCo or your dealer, check the following
list of suggestions. You might be able to solve the problem yourself.
Q: Unit Is Not Responding Properly to Commands.
Remove batteries. Unplug AC adapter for ten seconds then restore power.
Replace batteries.
Q: It’s not announcing calls or messages
Make sure the volume is set correctly (see ADJUST VOLUME mode)
Call the telephone company to make sure caller ID service has been activated
and is working with your line properly.
Make sure the batteries are good or the power cord is correctly plugged in.
Make sure the phone line coming from the wall is going to the LINE jack on the
unit and the phone cord coming from your phone is going to the PHONE jack
on the unit.
Let the phone ring twice before answering, as caller ID information is
announced between the first and second rings.
If you see the words DATA ERROR it means the message is not being
properly received by your unit. This could be a problem with the phone
company’s service or with your unit. Check your connections first.
Q: It’s not announcing call-waiting calls
Make sure the volume is set correctly (see ADJUST VOLUME mode)
Make sure you’re talking on the phone plugged into the back of the caller ID
unit
Make sure the phone line coming from the wall is going to the LINE jack on the
unit and the phone cord coming from your phone is going to the PHONE jack
on the unit.
If you have another call waiting ID device, try unplugging it.