Clay Paky SUPERSHARPY - Manual (Page 22)

22 SUPERSHARPY
FANS MONITOR
It lets you view the speed of each fan installed in the projector:
•
Lamp (lamp cooling fan)
• Pwr.Sup (PSU cooling fan)
HEAD POSITION
It lets you view the projector head position with reference to the X, Y and Z axes. It also provides further information on:
•
Good pkt: number of correctly received signal packets
• Bad pkt: number of incorrectly received signal packets
• Uart Err.: UART reception errors
BALLAST FIRMWARE VERSION
It lets you view the firmware versions of the Ballast inside the fixture.
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the projector, each channel is associated with one of
the following three parameters:
•
n.a.= sensor not available
• ON= sensor working
• OFF= sensor defective
ROT GOBOS INDEXING
It lets you check whether the rotating gobo wheel gobo indexing procedure should be run, if indexed, "Indexing Active"
appears on the display, otherwise "Indexing required!” appears
If necessary, indexing should be activated from the Advanced menu.
NETWORK PARAMS
Lets you view the projector "Network" parameters meaning:
IP address: Internet Protocol address (two projectors must not have the same IP address)
IP mask: 255.0.0.0
Mac address: Media Access Control; the projector’s Ethernet Address.