Clearaudio INNOVATION + STROBOSCOPE TESTRECORD - Manual (Page 9)

Innovation /
Innovation Wood
User manual
Page 8  Clearaudio electronic GmbH 2015
5.)
Take the stainless steel platter with both hands carefully out of the box.
Remove the lamination of the scale ring on the lower side of the turntable.
Please remove the lamination extreme carefully and avoid any soiling and
scratches.
Push the delivered bearing part carefully through the hole in the stainless steel sub-platter
and mount the bearing part with the sub-platter by using the mounting clip.
6.)
In the next step remove the lamination of the sensor mounted on the turntable chassis
(picture 6: red frame).
Please remove the lamination extreme carefully and avoid any soiling and
scratches.
7.)
With both hands you can place the stainless steel platter
carefully onto the bearing.
Through a lightly (!!) up and down movement the platter will
slip onto the bearing upper part (picture 7).
Make sure with gentle pressure that the platter is applying on
the complete surface of the bearing.
Avoid major side forces to avoid any damages to the
ceramic bearing!
Pic. 6: Removing the lamination
Pic. 5: Connection sub-platter and bearing upper part
Pic. 7: Set up stainless steel platter
with upper bearing part