Pre-installation important safety instructions, Screen operation – Da-Lite Ascender Electrol User Manual

Page 2

Advertising
background image

2

ATTENTION! Les ressorts des bras de l'écran sont fortement
tendus.

Ne vous placez pas devant l'écran pendant son
fonctionnement.

Ne vous asseyez pas, ne vous tenez pas debout, ou ne placez
aucun objet sur la trappe du caisson de l'écran.

Ne couvrez pas la trappe du caisson de l'écran avec un
revêtement en bois, de la moquette, des stratifiés
supplémentaires, etc. Tout poids ajouté à la trappe du
caisson de l'écran pourrait entraîner, avec le temps, le
dysfonctionnement de l'écran.

La trappe du caisson active un interrupteur de sécurité situé
à l'intérieur du caisson de l'écran. Si vous essayez d'élever
l'écran alors que quelque chose tient la trappe fermée, le
moteur rétractera l'écran. La trappe doit être complètement
fermée pour activer cet interrupteur. Vérifiez que la trappe
n'est pas entrouverte.

Pre-Installation

Important Safety Instructions

When using your video equipment, basic safety precautions should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or

contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating at

least equal to that of the appliance should be used. Cords rated
for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric shock
when the appliance is used subsequently.

5. The use of an accessory attachment not recommended by the

manufacturer may cause a risk of fire, electric shock, or injury to
persons.

Save These Instructions

1. The Ascender screen must be installed on a flat, level surface.

2. Remove the white shipping braces (mounted at the end of the arms to the back of the case).

3. Refer to the chart below for minimum overhead clearance required to raise the screen.

4. Allow 12" clearance from back of screen housing to allow arms to extend properly.

5. Remove packing paper from fabric roller. DO NOT use a knife or sharp object to remove the paper.

Screen Operation

CAUTION!

The arms of the screen are under high spring tension.

Do not stand over the screen while it is operating.

Do not sit, stand, or put anything on the screen case door.

Do not apply anything (wood finish, carpet, additional
laminate, etc.) to the screen case door. Any weight added to
the screen case door may cause the screen to malfunction
over time.

The case door activates a safety switch inside the screen
case. If you attempt to raise the screen while something is
holding the door shut, the motor will reverse and retract the
screen. The door must be fully closed to activate this switch.
Be sure there is nothing holding the door ajar.

Diagonal

Extended Height

100"

94"

120"

104"

150"

121"

180"

139"

200"

149"

Diagonal

Extended Height

106"

86"

119"

92"

133"

99"

159"

112"

4:3 Video Format

16:9 HDTVFormat

Advertising
This manual is related to the following products: