Da-Lite Contour Electrol - Manual (Page 3)

3
Installation (continued)
1/4 X 5/8"
Flat Head Screw
Ceiling Hook Bracket
Wall Mount
Bracket
Wall
1/4 X 5/8"
Flat Head
Screw
3. Make sure the bracket is level.
4. Hang the screen case on the wall mount bracket as shown in
(Figure 2). Be sure the case is fully seated on the bracket.
5. Tighten the two stop screws against the wall mount bracket
using a #2 Phillips screwdriver (Figure 1).
Ceiling Flush Mount
1. The ceiling hook brackets are attached to the top side of the
housing. They must be removed prior to ceiling flush mount.
NOTE: Do not remove the wall mount bracket, even if you are
not using it for mounting. This provides structural stability to
the case.
2. Using a #2 Phillips screwdriver, loosen the four 1/4”x 5/8” screws
holding the ceiling flush mount brackets (Figure 3).
3. Slide the ceiling flush mount brackets so that the mounting
holes extend beyond the ends of the case. All four 1/4”x 5/8”
screws must remain within the channels.
4. Tighten the four 1/4”x 5/8” screws holding the ceiling flush
mount brackets (Figure 3).
5. Before mounting your Contour Electrol, be sure the ceiling
has adequate reinforcement.
6. Hold the screen case up to the ceiling and mark the hole
locations. The brackets have a set of front holes and a set of
rear holes. Attach the Contour Electrol using the appropriate
hardware for your ceiling type. It is best to use at least one
hole in each set.
Ceiling Hook Mount
1. The ceiling hook mount brackets are tied together and
attached to the ceiling flush mount bracket at one end
of the case. Remove the ceiling hook mount brackets.
2. Remove the ceiling flush mount brackets using a #2 Phillips
screwdriver (Figure 3). Retain four 1/4”x 5/8” screws.
NOTE: Do not remove the wall mount bracket, even if you
are not using it for mounting. This provides structural stability
to the case.
3. The top of the screen case has two channels with threaded
nuts that slide the length of the case. Attach the two ceiling
hook mount brackets using the 1/4”x 5/8” screws and threaded
nuts, two per bracket. The brackets can be attached anywhere
within 12" of the ends of the case (Figure 4).
4. Before hanging your Contour Electrol, be sure the ceiling
has adequate reinforcement.
5. Using the holes in the ceiling hook brackets, hang the
Contour Electrol using the appropriate hardware and
fasteners for your ceiling type. Figure 4
Figure 3
Figure 2